Mini Sabre Vanes
Weight: 6.0 +/-0.1 Grains
Height: .465 Inches
Length: 2 Inches
RIDICULOUSLY TOUGH MATERIAL
This is the same material used on the outside of golf balls! The material can be stretched and returned to shape. Pass-throughs on targets are no problem. It is recommended to use the Sabre Primer Pen along with Bob Smith Maxi-Cure adhesive for almost permanent bond.
INDIVIDUALLY MOLDED
The Mini Sabres are all very consistent. Shown by the weight consistency of 6.0 +/-0.1 gr. All exactly identical. The 8-cavity mold means there will not be any shortages moving forward.
SCIENTIFICALLY DEVELOPED OVER 2 YEARS USING
- CFD - Computational Fluid Dynamics
- NASA Stability Calculations
- A Custom Wind Tunnel
- A LabRadar (Doppler Radar)
Application Method
- Clean the arrow shaft or wrap with a clean, dry paper towel. Do not use acetone.
- Place Super Sabre in the fletching jig clamp. 2.5 degree helical is recommended as a starting point, but not required (left or right). If you are using the OMP jig and can pick either 2 or 3 degrees. Go with 2 if you want to lean towards speed, 3 if you want to lean towards stability.
- Prep the base using the Sabre Primer Pen for a rock solid almost permanent bond.
- Apply a very thin continuous bead of Maxi-Cure (recommended) to the base. Do not spread it out.
- Using press the vane down holding it securely for 10 sec. (or recommended time on adhesive).
- Unclamp the vane and wipe excess glue from around the base of the vane.
- Let the adhesive cure for 10-15 min.
